Blower Control Module Replacement - HVAC System - Automatic

REMOVAL PROCEDURE




1. Disconnect the pigtail harness connectors (1 and 2) from the blower motor.




2. Disconnect the electrical connector (4) from the blower motor control module (2).
3. Remove the blower motor control module mounting screws (1).
4. Remove the blower motor control module (2) from the blower case.

INSTALLATION PROCEDURE




1. Install the blower motor control module (2) to the blower case.
2. Install the blower motor control module mounting screws (1).

Tighten
Tighten the screws to 1.9 N.m (17 lb in).

3. Connect the electrical connector (4) to the blower motor control module (2).




4. Connect the pigtail harness connectors (1 and 2) to the blower motor.