Park/Neutral Position Switch: Installation

NOTE: Do not rotate a new PNP switch. A new PNP switch is pinned in the Neutral position. If the bolt holes do not align with the mounting boss on the transaxle, verify that the shaft is in the Neutral position.

Verify that the shift shaft in the Neutral position. Adjust the PNP switch if the new switch has been rotated and the pin is broken or if using an old PNP switch. See PARK/NEUTRAL POSITION SWITCH under ADJUSTMENTS. Align the flats of the shift shaft to the flats in the PNP switch. Install the PNP switch to the mounting boss. See Figure . Install the PNP switch mounting bolts. Tighten the PNP switch mounting bolts to specification. See TORQUE SPECIFICATIONS . Install the manual selector lever. Install the wiring harness connectors. Install the shift cable. Verify that the engine starts only in the Park position or the Neutral position once the PNP switch is installed. Readjust the PNP switch and/or inspect the shifter and the automatic transaxle range selector lever if the engine starts in any other position. Install the throttle body air inlet duct. Remove the blocks from the wheels. Release the parking brake.