TCC Pulse Width Modulation Solenoid: Installation
- Install the TCC PWM solenoid (334). Install the TCC PWM solenoid retaining clip (314F). Connect the TCC PWM solenoid electrical connector.
- Install the oil pump to the valve body. See Figure
. Install the oil pump bolts (206, 207) and tighten as follows:
- Bolt No. 207 - 106 INCH lbs. (12 N.m).
- Bolt No. 206 - 12 ft. lbs. (16 N.m).
See Figure .
- Reposition and connect the electrical connectors to the following:
- Fluid pressure manual valve position switch assembly. See Figure .
- 2-3 Shift solenoid valve assembly.
- Install the case side cover. See CASE SIDE COVER .