10 Minute Learn Procedure
WARNING: This page is about a different car, the 2001 Cadillac Eldorado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A Tech 2 and Techline terminal with current Service Programming System (SPS) software is required.
- Connect Tech 2 to vehicle.
- Select REQUEST INFORMATION under SERVICE PROGRAMMING.
- Disconnect Tech 2 from vehicle and connect it to a Techline terminal.
- On Techline terminal, select THEFT MODULE RE-LEARN under SERVICE PROGRAMMING.
- Disconnect Tech 2 from Techline terminal and connect it to vehicle.
- Turn ignition switch to RUN position.
- Select VTD RE-LEARN under SERVICE PROGRAMMING.
- Attempt to start engine, then release key to RUN position (vehicle will not start).
- Observe SECURITY indicator. After 10 minutes, SECURITY indicator will turn off. Vehicle is now ready to relearn password on next ignition switch transition from OFF to START.
- Turn ignition switch to OFF position, and wait 5 seconds.
- Start engine. Vehicle has now learned password.
- Using Tech 2 scan tool, clear any DTCs.