Specifications Index
BRAVADA, ENVOY & TRAIL BLAZER SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | FASTENER TIGHTENING SPECIFICATIONS | |
| Axle Nut/Hub Nut | 103 Ft. Lbs. (140 N.m) | |
| Battery | BATTERY SPECIFICATIONS | |
| Brakes | ||
| Bleeding Sequence | RR, LR, RF, LF | |
| Disc Brakes | BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 15 psi or specification stamped on cap. | |
| Thermostat R & I | THERMOSTAT HOUSING REMOVAL | |
| Water Pump R & I | WATER PUMP REMOVAL | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION | |
| Oil Pressure | Minimum 12 psi (85 kPa) at 1200 RPM (at the sending unit) warm | |
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | |
| Torque | FASTENER TIGHTENING SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | First Pass 18 Ft. Lbs. (25 N.m) Final Pass 50 degrees |
|
| Fuel System | ||
| Pressure Specification | 48-52 psi (331.0-358.5 kPa) | |
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST (4.2L) | |
| Ignition | ||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Resistance) | Not equipped with high tension wires. Ignition coils are connected directly to spark plugs by boots. | |
| Ignition Wires (Routing) | N/A | |
| Spark Plug | ||
| Type | AC 41-965 | |
| Gap | .050 In. (1.27 mm) | |
| Torque | 13 Ft. Lbs. (18 N.m) | |
| Starting | ||
| Starter | PG-260L | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | FASTENER TIGHTENING SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 103 Ft. Lbs. (140 N.m) Tighten in a crisscross pattern. |
|