Ignition Control Module Replacement - Bank 2

REMOVAL PROCEDURE




1. Remove the ignition cassette.
2. Remove the ignition control module retaining screws.
3. Remove the ignition control module.

INSTALLATION PROCEDURE




1. Install the ignition control module.
2. Install the ignition control module retaining screws

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the ignition control module retaining screws to 0.8 N.m (7 lb in).

3. Connect the spark plug boots to the spark plugs.

IMPORTANT: Ensure that the ignition cassette grounding spring and the insulator are in place when installing the ignition cassette.

4. Install the ignition cassette.