LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1742 (Engine Control System - 4.2L - Introduction) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Sender Assembly
    GM734516Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (TrailBlazer EXT, Envoy XL, Envoy XUV)  or Fuel Tank Replacement (TrailBlazer, Envoy, Rainier) .
    2. NOTE: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the joints.
  2. Use the J 44402  to remove the fuel sender assembly retaining ring. See Special Tools & Equipment .
  3. Remove the fuel sender assembly and the seal. Discard the seal.
    CAUTION: Drain the fuel from the fuel sender assembly into an approved container in order to reduce the risk of fire and personal injury. Never store the fuel in an open container.
  4. Clean the fuel sender sealing surfaces.
scientia non olet · About LEMON Manuals