Assembly Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the service port cap (7) and valve (6) to the fuel rail (5).
- Lubricate the NEW fuel rail crossover pipe O-rings (11) with clean engine oil.
- Install the NEW fuel rail crossover pipe O-rings (11) onto the crossover pipe (10).
- Install the fuel rail crossover pipe (10) to the left and right hand fuel rails.
- Install the fuel rail crossover fuel pipe retainer clips (9).
- Install the fuel rail retainer clip screws (8) but do not tighten at this time.
- Install the fuel injectors (2) to the fuel rail (5). Refer to Fuel Injector Replacement .
IMPORTANT:
When installing the retaining clip screws for the fuel rail crossover pipe, always start the screws by hand. This will prevent stripping of the threads on the fuel rail.