Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing PSIR Inflator Module

Courtesy of GENERAL MOTORS CORP.

Install the PSIR inflator module to the front of the I/P carrier.

Fig 2: Removing/Installing Side Retaining Nuts At PSIR Inflator Module

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 side retaining nuts to the PSIR inflator module.
Tighten: Tighten the nuts until fully driven, seated and not stripped.

Fig 3: Removing/Installing 2 Lower Passenger Supplemental Inflatable Restraint (PSIR) Inflator Module Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 2 retaining bolts (1) to the PSIR inflator module.
Tighten: Tighten the bolts until fully driven, seated and not stripped.

Fig 4: Removing/Installing Air Duct Extension

Courtesy of GENERAL MOTORS CORP.

Install the passenger air duct extension though the front of the I/P.

Fig 5: Removing/Installing Passenger Air Duct Extension Screw

Courtesy of GENERAL MOTORS CORP.

Install the passenger air duct extension screw (1).
Tighten: Tighten the screw to 2.5 N.m (22 lb in).
Close the I/P compartment door.

Fig 6: Identifying Right I/P Access Cover

Courtesy of GENERAL MOTORS CORP.

Install the passenger side I/P access panel.
Enable the SIR System. Refer to SIR Disabling and Enabling Zone 5 .