LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1744 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the SIR wiring harness to the module.
    2. Fig 1: Inflatable Side Impact Module Screw
    GM753528Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the inflatable side impact module to the seat back frame with the 2 screws (1).

    Tighten:  Tighten the screws to 9 N.m (80 lb in).

    3. Fig 2: Removing/Installing Seat Belt Retractor Bracket Bolt
    GM757363Courtesy of GENERAL MOTORS CORP.
  3. Install the top of the seat belt retractor assembly to the seat back frame with the plastic push pin (2).
  4. Install the front seat back panel. Refer to Seat Back Panel Replacement - Front in Seats.
  5. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front in Seats.
  6. Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement in Seats.
  7. Install the seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket in Seats.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  and SIR Disabling and Enabling Zone 6 .
scientia non olet · About LEMON Manuals