Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.

CAUTION: Refer to SIR Caution in Cautions and Notices.

CAUTION: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

The seat cushion frame
The seat recliner, if equipped
The seat adjuster
The seat back frame

Failure to do so may cause future personal injury.

Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6 .
Remove the seat assembly from the vehicle. Refer to Seat Replacement - Front Bucket in Seats.
Remove the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement in Seats.
Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front in Seats.
Remove the front seat back panel. Refer to Seat Back Panel Replacement - Front in Seats.

Fig 1: Removing/Installing Seat Belt Retractor Bracket Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the push pin (2) securing the top of the seat belt retractor assembly to the seat back frame.

Fig 2: Inflatable Side Impact Module Screw

Courtesy of GENERAL MOTORS CORP.

Remove the 2 screws (1) that secure the inflatable side impact module to the seat back frame.
Disconnect the SIR wiring harness from the module.
Remove the side impact module.
Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .