LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1769 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
    Fig 1: TORX® Screw Heads
    GM778153Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install EBCM on to the BPMV.
    2. NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  2. Install the 4 new T-25 TORX® screws in the EBCM.

    Tighten:  Tighten the 4 T-25 TORX® screws to 5 N.m (39 lb in) in an X-pattern.

    3. Fig 2: Removing/Installing EBCM Electrical Connectors (Side)
    GM777346Courtesy of GENERAL MOTORS CORP.
  3. Install the 2 electrical connectors on the side of the EBCM.
    4. Fig 3: Removing/Installing EBCM Electrical Connectors (Back)
    GM778100Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical connector on the back of the EBCM.
  5. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  6. Revise the tire calibration using the Scan Tool Tire Size Calibration function.
scientia non olet · About LEMON Manuals