LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 1988 >> Gran Fury Base >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Overhaul >> Disassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition System: Overhaul: Disassembly

  1. Remove distributor cap. Using 2 screwdrivers, pry off rotor from shaft. Remove reluctor by prying up from bottom of reluctor using 2 pry bars or screwdrivers with a maximum width of 7/16". Be careful not to distort or damage reluctor teeth.
  2. Remove 2 screws and lock washers attaching plate to housing. Lift out plate and pick-up coils as an assembly. Do not attempt to remove distributor cap clamps.
  3. If distributor has more than .006" (.15 mm) shaft side play, replace housing shaft and reluctor sleeve by removing shaft retaining pin and sliding retainer off end of shaft.
  4. Use a file to clean burrs from around pin hole in shaft and remove lower thrust washer. Push shaft up and remove shaft through top of distributor housing.
scientia non olet · About LEMON Manuals