Test 32A - Courtesy Lights On At All Times
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see WIRING DIAGRAMS
article in the ENGINE PERFORMANCE Section. Perform TEST VER - 1A after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Ensure all doors are closed and dimmer switch on left pod switch is in center position. Using DRB-II, read door ajar switch status. If DRB-II does not display LFDOOR AJAR:OPEN, go to TEST 40A. If DRB-II displays LFDOOR AJAR:OPEN, go to next step.
- If DRB-II does not display RFDOOR AJAR:OPEN, go to TEST 41A. If DRB-II displays RFDOOR AJAR:OPEN, go to next step.
- If DRB-II does not display SIDE DR AJR:OPEN, go to TEST 42A. If DRB-II displays SIDE DR AJR:OPEN, go to next step.
- If DRB-II does not display GATE AJAR:OPEN, go to TEST 43A. If DRB-II displays GATE AJAR:OPEN, go to next step.
- Turn ignition off. Gain access to body controller, located under left side of instrument panel. Disconnect body controller connectors. If courtesy lights stay on all the time, repair short to ground in Yellow wire. If courtesy lights do not stay on all the time, go to next step.
- Using DRB-II in ohmmeter mode, measure resistance of switch sense circuit at Blue body controller connector terminal No. 1 (Black/Light Blue wire). If resistance is more than 5 ohms, replace body controller. If resistance is less than 5 ohms, go to next step.
- Disconnect Black left pod switch connector. Measure resistance of switch sense circuit at Blue body controller connector terminal No. 1 (Black/Light Blue wire). If resistance is more than 5 ohms, replace left pod switch. If resistance is less than 5 ohms, repair short to ground in Black/Light Blue wire.