LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Plymouth >> 2000 >> Neon Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> System Tests >> Brake Switch Sense Status Does Not Change On Scan Tool >> Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Switch Sense Status Does Not Change On Scan Tool: Testing

  1. Turn ignition off. Disconnect brake switch connector. Inspect connector and clean or repair as necessary. Using DVOM, measure resistance between brake switch connector terminal No. 2 (Black/Tan wire) and ground. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Black/Tan wire. Perform TEST VER-4A  under VERIFICATION TESTS.
  2. Disconnect PCM connector C2. Using DVOM, measure resistance of White/Pink wire between PCM connector C2 terminal No. 62 and brake switch terminal No. 1. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in White/Pink wire. Perform TEST VER-4A  under VERIFICATION TESTS.
  3. Using DVOM, measure resistance between brake switch terminal No. 1 (White/Pink wire) and ground. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground in White/Pink wire. Perform TEST VER-4A  under VERIFICATION TESTS.
    NOTE: Ensure brake pedal is not depressed during next step.
  4. Using DVOM, measure resistance between brake switch terminals No. 1 and 2 (switch side). If resistance is 5 ohms or more, go to next step. If resistance less than 5 ohms, replace brake switch. See BRAKE SWITCH  under REMOVAL & INSTALLATION. Perform TEST VER-4A  under VERIFICATION TESTS.
  5. Replace PCM. Perform TEST VER-4A  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals