Control Module: Service and Repair

REMOVAL
1. Raise deck lid.
2. Disconnect battery negative cable.
3. Loosen 60 way retaining screw, located in the center of the 60 way connector. Then disconnect the 60 way connector on transmission control module.

Fig. 64:

4. Remove transmission control module mounting screws and lift module from vehicle (Fig. 64).

INSTALLATION
1. Install transmission control module and tighten mounting screws.
2. Install 60 way connector. Tighten 60 way retaining screw to 4 Nm (35 inch lbs.).
3. Connect battery negative cable.