Crankshaft Position Sensor: Service and Repair

Typical DIS Crankshaft Sensor:

REMOVE OR DISCONNECT:

1. Negative battery cable.
2. Electrical connector from the crankshaft sensor.
3. Sensor hold-down bolt.
4. Sensor from engine.
5. Inspect the crankshaft sensor O-ring for cracks, wear or leakage. Before installing new sensor, lubricate the new O-ring with engine oil.


INSTALL OR CONNECT:

1. New sensor into the hole in the engine block.
2. Tighten the sensor hold-down bolt and torque to 8 Nm (71 lb in).
3. Crankshaft sensor electrical connection.
4. Negative battery cable.
5. Before starting engine perform IDLE LEARN PROCEDURE. Refer to ADJUSTMENT PROCEDURES/IDLE LEARN PROCEDURE.