Knock Sensor Module: Service and Repair

PCM Location:

Removing Knock Sensor Module From PCM:

REMOVAL PROCEDURE
1. Remove the PCM. If installing a new PCM, check the service number to make sure it is the same number or updated number as the faulty PCM.
2. Remove the KS module cover.

INSTALLATION PROCEDURE
Refer to the Latest Techline Information on Re-Programming or Flashing procedures.

1. Install the KS module in KS module socket.
2. Install the KS module cover.

Tighten
Cover screws to 2.8 - 3.2 Nm (25-28 lb. in.).