EEPROM Programming

Programming
1. Set-up - Ensure that the following conditions have been met;

^ The battery is fully charged.

^ The ignition is ON.

^ The Vehicle Interface Module cable connection at the DLC is secure.

2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment users instructions.

3. If the PCM fails to program, proceed as follows:

^ Ensure that all PCM connections are OK.

^ Check the Techline equipment for the latest software version.

^ Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. You must program the replacement PCM.


Functional Check
1. Perform On-Board Diagnostic System Check.

2. Start engine and run for one minute.

3. Scan for DTCs using the scan tool.

4. If DTC P0325 sets, the KS module is not fully seated, is missing, or is faulty.