Control Assembly Replacement

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the instrument panel cluster trim plate.
3. Remove the HVAC control assembly mounting bolts.




4. Disconnect the electrical connector.
5. Remove the HVAC control assembly.

INSTALLATION PROCEDURE




1. Connect the electrical connector.




2. Install the HVAC control assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the HVAC control assembly mounting bolts.

Tighten
Tighten the control assembly bolts to 2 N.m (18 lb in).

4. Install the instrument panel cluster trim plate.
5. Connect the negative battery cable.