Camshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the camshaft position sensor.
3. Remove the camshaft position sensor retaining screw.
4. Remove the Camshaft Position (CMP) sensor from the engine front cover.

INSTALLATION PROCEDURE

1. Install the camshaft position sensor to the engine front cover.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the camshaft position sensor retaining bolt.

Tighten
Tighten the bolt to 5 N.m (44 lb in).

3. Connect the camshaft position sensor electrical connector.
4. Reconnect the negative battery cable.