Powertrain Control Module
NOTE:
When replacing the production powertrain control module (PCM) with a service PCM (controller), it is important to transfer the broadcast code and production PCM number to the service PCM label. Do not record this information on the PCM cover. Transfer allows positive identification of PCM parts throughout the service life of the vehicle. Service of the PCM should normally consist of either replacement of the PCM or Electrically Erasable Programmable Read Only Memory (EEPROM) programming. If the diagnostic procedures call for PCM replacement, inspect the PCM first to see if the PCM is the correct part. If the PCM is faulty, remove the PCM and install the new service PCM. The new service PCM will not be programmed. You must program the new PCM. DTC P0602 indicates the EEPROM is not programmed or has malfunctioned. There are not any user-serviceable parts in this PCM. The PCM should never be opened for any reason.
Disconnect the negative battery cable. Remove the front fender upper left sheet metal diagonal brace. Remove the air cleaner assembly cover, and lift the PCM from the assembly. Disconnect the harness connectors from the PCM. Remove the PCM from the engine compartment. To install, reverse removal procedure. If a new PCM is being installed, program the EEPROM.