LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1067 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Replacement (Aztek) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Driver Inflator Module Components
    GM255209Courtesy of GENERAL MOTORS CORP.
  1. Connect the horn ground lead (2) into the lower left threaded hole in the steering wheel.
  2. Connect the horn contact lead into the steering column cam tower.
  3. Rotate the horn contact turn 1/4 turn clockwise to lock.
  4. Connect the inflator module electrical connector and the CPA (4).
    IMPORTANT: Route the driver inflator wires, the redundant control wires, and the horn wires correctly.
  5. Align the driver inflator module fasteners to the steering column fastener holes.
  6. Push the driver inflator module firmly into the steering column in order to engage the fasteners.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  8. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
scientia non olet · About LEMON Manuals