Fuel Level Sensor: Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Install the fuel level sensor by sliding the sensor down in the housing. Slide the upper reservoir into the lower reservoir. Connect the 2 wires into the connector and lock the connector with the retaining clip. Connect the fuel pump and fuel level sensor electrical connector and lock the connector with the retaining clip. Install the fuel sender assembly.

NOTE: Make sure the wires are routed under the fuel level sensor. Make sure the tab locks in place.