LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1254 (Body Rear End) >> Repair Instructions >> Lift Gate Replacement (Aztek) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Aztek and 2002 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the liftgate hinges to the marked location points on the liftgate, with an assistant.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts to the liftgate hinges, with an assistant.

    Tighten 

    Tighten the liftgate hinge bolts to 33 N.m (28 lb ft).

  3. Install the liftgate struts. Refer to Strut Replacement - Lift Gate .
  4. Install the liftgate latch strikers. Refer to Latch Striker Replacement - Lift Gate (Aztek) .
  5. Install the liftgate bumper mounting brackets.
  6. Install the liftgate window. Refer to WINDOW REPLACEMENT - LIFT GATE (PONTIAC) .
    Fig 1: Installing Bolts From Liftgate Hinges (Aztek)
    G01722807Courtesy of GENERAL MOTORS CORP.
  7. Install the upper and lower liftgate trim panels. Refer to Trim Panel Replacement - Lift Gate (Aztek) .
  8. Adjust the liftgate as required. Refer to. Hinge Replacement - End Gate 
scientia non olet · About LEMON Manuals