Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Side Window Filler Panel To Windshield Pillar

Courtesy of GENERAL MOTORS CORP.

Apply a continuous bead of sealant GM P/N 12345097, or equivalent, to the side window filler panel along the surface that will contact the windshield pillar as illustrated.

Fig 2: Filler Panel To Windshield Pillar

Courtesy of GENERAL MOTORS CORP.

Position the filler panel to the windshield pillar.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws attaching the side window filler panel.
Tighten: Tighten the filler panel screws to 2.5 N.m (22 lb in).
Wipe off any excessive sealant that squeezed out around the filler panel.
Install the windshield side reveal molding, the side weatherstrip retainer, and the weatherstrip. Refer to Side Reveal Molding Replacement (Coupe and Convertible) or Side Reveal Molding Replacement (Hardtop) .