Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
- Install the windshield side reveal moldings. Refer to Side Reveal Molding Replacement (Coupe and Convertible) or Side Reveal Molding Replacement (Hardtop) .
- Install the windshield weatherstrip. Refer to Weatherstrip Replacement (Coupe and Convertible) or Weatherstrip Replacement (Hardtop) .
- Install the fender mounting screws.
Tighten: Tighten the fender upper flange screws to 1.9 N.m (17 lb in).
- Install the air inlet screen. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Install the air inlet screen seal. Refer to Seal Replacement - Hood Rear in Body Front End.
- Install the windshield wiper arms and washer hoses. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
- Install the windshield side garnish moldings.
- Remove the rearview mirror. Refer to Rearview Mirror Replacement (Base) or Rearview Mirror Replacement (DD8) .
- Install the roof lift off panel (coupe) or raise and close the folding top (convertible).
- Close the door windows.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Close the hood.
NOTE:
Refer to Fastener Notice in Cautions and Notices.