LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1424 (Stationary Window System) >> Repair Instructions >> Windshield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
    2. Fig 1: Window Side Reveal Molding
    GM398501Courtesy of GENERAL MOTORS CORP.
  2. Install the window side reveal moldings to the vehicle.
    3. Fig 2: Removing Window Side Reveal Molding Screws
    GM398502Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the screws to the left and the right sides of the window side reveal moldings.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 3: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  4. Install the front door sealing weatherstrips (1) to the retainer (2).
  5. Install the cowl air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
  6. Install the window wiper arms. Refer to WIPER ARM REPLACEMENT .
  7. Install the antenna mast, if equipped. Refer to FIXED ANTENNA REPLACEMENT .
  8. Install the rearview mirror. Refer to Rearview Mirror Replacement .
  9. Close the hood.
  10. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
scientia non olet · About LEMON Manuals