LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1534 (Power Door Lock System And Release Systems) >> Repair Instructions >> Door Inside Handle Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inside Door Handle
    GM943413Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the power window switch.
  2. Position the inside handle to the door trim and partially seat the rear tangs.
  3. Lift the lock rods into the retaining clips. Secure the rods into the handle by latching the clips over the rods.
  4. Push the handle into the trim panel and slide rearward to fully engage the tangs. Verify that the rods clear the water deflector.
    5. NOTE: Refer to Fastener Notice .
  5. Install the screw in the handle.

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in).

  6. Install the inside handle fastener cover.
  7. Verify the correct installation of the lock rods by testing for smooth movement of the lock button and of the inside handle.
scientia non olet · About LEMON Manuals