LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 607 (Rear Wheel Steering System) >> Repair Instructions >> Rear Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Make sure the O-ring (1) is installed.

  1. Install the rear wheel position sensor (2) to the steering gear.

    Important:  Be careful to maintain the position of the replacement sensor.

  2. Remove the pin retaining the position of the new sensor and immediately install the sensor to the steering gear.
  3. Install the rear wheel position sensor retaining bolts. Apply LOCTITE 242 blue. Tighten the bolts to 4 N.m (35 in lbs).
  4. Install the rear wheel position sensor cover (4).
  5. Connect the electrical connector (1).
  6. Install the steering gear protection shield (1) and retaining bolts (3). Tighten the steering gear protection shield retaining bolts to 180 N.m (132 ft lbs).
  7. Lower the vehicle.
  8. Perform a four wheel alignment. Refer to SPECIFICATIONS .
scientia non olet · About LEMON Manuals