LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 852 (Seat System) >> Repair Instructions >> Memory Seat Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly
  3. Remove the fasteners.
    Fig 1: Removing Fasteners From Seat Cushion Assembly
    G01518114Courtesy of GENERAL MOTORS CORP.
  4. Adjust the front seat assembly to the rear of the vehicle.
  5. Angle the front seat cushion (1) up, in order to access the assembly fasteners (2).
  6. Remove the fasteners.
  7. Lift the front seat cushion assembly (1) away from the seat riser.
    Fig 2: Lifting Front Seat Cushion Assembly Away From Seat Riser
    G01518115Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the electrical connector.
  9. Using a flat-bladed tool, release the module from the bracket.
  10. Remove the memory seat module from the seat frame.
    Fig 3: Removing Memory Seat Module From Seat Frame
    G01518116Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals