Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Important: Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
- Install EBCM (2) on to the BPMV (3).NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the four new T-25 TORX® screws (1) in the EBCM (2).
Tighten
Tighten the four T-25 TORX® screws to 5 N.m (39 lb in) in an X-pattern.
- Connect the electrical connectors to the EBCM (2).
- Revise the tire calibration using the Scan Tool Tire Size Calibration function.