LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 941 (Engine Controls - 8.1L (Introduction)) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • To prevent internal PCM damage, the ignition switch must be OFF when disconnecting or connecting power to the PCM.
  • Remove any debris from around the PCM connector surfaces before servicing the PCM. Inspect the PCM module connector gaskets when diagnosing or replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the PCM.
  • The replacement PCM must programmed.
    IMPORTANT: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100%. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5000 km (3,000 mi) from the last engine oil change.
  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
  3. If equipped with the Allison transmission regular production option (RPO) M74, remove the engine harness clip from the PCM cover.
    Fig 1: Locating PCM Cover
    GM877692Courtesy of GENERAL MOTORS CORP.
    4. Fig 2: View Of PCM Cover & Mounting Bracket
    GM814118Courtesy of GENERAL MOTORS CORP.
  4. Release the PCM cover mounting tabs.
  5. Release the PCM cover from the mounting bracket.
  6. Remove the PCM cover.
    7. Fig 3: View Of PCM Electrical Connectors
    GM814117Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to PCM and ESD Notice in Cautions and Notices.
    NOTE: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
  7. Loosen the PCM electrical connector bolts (2).
  8. Disconnect the PCM electrical connectors.
    9. Fig 4: View Of PCM
    GM814119Courtesy of GENERAL MOTORS CORP.
  9. Release the spring latch from the PCM.
  10. Release the PCM mounting tabs from the PCM.
  11. Remove the PCM.
scientia non olet · About LEMON Manuals