Data Definitions
- Brake Pedal Travel - -50 to 200 mm (-1.97 to 7.87 in)
-
This data represents the chord length translation position of the brake pedal through its normal range of movement.
- BPP Sensor Rate - 0 to +10%/25 ms
-
This data indicates the rate of change of the brake pedal.
- BPP Sensor Input Voltage - 0 to 5 Volts
-
This data represents the voltage being supplied to the BPP Sensor as measured by the EHPS system.
- BPP Sensor Output Voltage - 0 to 5 Volts
-
This data represents a raw brake pedal position indicated by the voltage being received by the EHPS module from the BPP Sensor as measured by the EHPS system.
- EHPS 42 V Bus Voltage - 0 to 76 Volts
-
This data indicates the voltage of the 42 V bus at the EHPS module.
- EHPS Ignition 0- OFF/ON
-
This data represents the voltage of the Accessory signal at the EHPS module as read by the EHPS system.
- EHPS Ignition 1 - OFF/ON
-
This data represents the voltage of the Ignition 1 signal at the EHPS module as read by the EHPS system.
- EHPS Demand - -100 to +100%
-
This data represents the percentage of the available EHPS pump output being delivered as determined by the EHPS system.
- EHPS Demand Speed - 0 to +7500 RPM
-
This data represents the current pump speed being commanded as determined by the EHPS system.
- EHPS ECU Temperature - -180 to +180°C (-238 to +302°F)
-
This data represents the temperature of the EHPS module in the EHPS system as determined by the EHPS system.
- EHPS Manifold Temperature - -180 to +180°C (-238 to +302 °F)
-
This data represents the temperature of the manifold in the EHPS system as determined by the EHPS system.
- EHPS Motor Current - 0 to +200 A
-
This data represents the current being used by the EHPS motor as measured by the EHPS system.
- EHPS Motor RPM - 0 to +7500 RPM
-
This data represents the rotational speed of the EHPS motor as determined by the EHPS system.
- Steering Wheel Rate - 0 to 2048°/s
-
This data represents the approximate degrees per second change of the steering wheel as determined by the EHPS system.
- Steering Wheel Sensor Phase A Volts - Low/High
-
This data represents the state of the Phase A digital output of the steering wheel sensor at the EHPS unit as currently read by the EHPS system.
- Steering Wheel Sensor Phase B Volts - Low/High
-
This data represents the state of the Phase B digital output of the steering wheel sensor at the EHPS unit as currently read by the EHPS system.
- Vehicle Speed - km/h (mph)
-
This data represents the calculated speed of the vehicle as determined by the PCM.