Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the control module to the vehicle.
- Install the control module (2) retaining bolts (1).
Tighten: Tighten the bolts to 24 N.m (18 lb ft).
- Connect the electrical connectors to the module.
- Program the control module. Refer to Service Programming System (SPS) in Programming.
- Install the spare tire to the vehicle.
- Lower the vehicle.
- Perform a learn alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
NOTE:
Refer to Fastener Notice in Cautions and Notices.