Steady State Adapts

The PCM monitors the ISS sensor and the VSS after an upshift to determine the amount of clutch slippage. If excessive slippage is detected, then the PCM will adjust the current to the PC solenoid valve to increase the line pressure to maintain the proper gear ratio for the commanded gear.

The Transmission Adaptive Pressure (TAP) information is divided into 13 units, called cells. The cells are numbered 4-16. Each cell represents a given torque range. TAP cell 4 is the lowest adaptable torque range and TAP cell 16 is the highest adaptable torque range. It is normal for TAP cell values to display zero or negative numbers. This indicates that the PCM has adjusted line pressure at or below the calibrated base pressure.