Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the XM digital radio receiver to the receiver bracket.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the radio receiver nuts.
Tighten: Tighten the nuts to 4 N.m (35 lb in).

Fig 1: View Of Radio Wiring Harness
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector and the antenna connectors to the XM radio receiver.

Fig 2: Identifying XM Digital Radio Receiver
Courtesy of GENERAL MOTORS CORP.
Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .