LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2001 >> Aztek Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1066 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Accelerator Controls Cable
    GM12831Courtesy of GENERAL MOTORS CORP.
  1. Remove the accelerator cable shield, if equipped.
  2. Disconnect the accelerator cable from the throttle body lever.
  3. Disconnect the accelerator cable from the accelerator cable bracket.
    4. Fig 2: View of Accelerator Pedal Assembly
    GM12826Courtesy of GENERAL MOTORS CORP.
  4. Remove the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges, and Console.
  5. Disconnect the accelerator cable from the accelerator pedal.
  6. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead.
    7. Fig 3: Illustrating Accelerator Cable Routing
    GM50638Courtesy of GENERAL MOTORS CORP.
  7. Remove the accelerator cable from the vehicle. Note the cable routing for aid in installation.
scientia non olet · About LEMON Manuals