Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Automatic Level Control Sensor Link Ball Stud

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ball stud to the rear lower control arm.
Tighten: Tighten the height sensor ball stud to 4 N.m (35 lb in).
Install the automatic level control sensor link to the lower control arm ball stud.
Lower the vehicle.