LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1249 (HVAC Systems - Automatic) >> Repair Instructions >> Blower Motor Control Processor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the blower motor control module to the HVAC module.
    2. Fig 1: Rear Blower Motor Control Module & Retaining Screw
    GM295320Courtesy of GENERAL MOTORS CORP.
  2. Position the blower motor control module forward retaining slots onto the forward retaining screws.
  3. Align and seat the blower control module to the HVAC module.
  4. Install the rear blower motor control module retaining screw.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten all the blower motor control module retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    6. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  6. Connect the blower motor electrical connector.
    7. Fig 3: Blower Motor Control Module Electrical Connector
    GM295319Courtesy of GENERAL MOTORS CORP.
  7. Connect the blower motor control module electrical connector.
  8. Install the I/P lower insulator panel - RH. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals