Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the sun load sensor to the vehicle.

Fig 1: Connecting Sun Load Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the sun load sensor electrical connector.
Rotate to secure the sun load sensor to the defroster grille.

Fig 2: I/P Upper Trim Pad & Windshield Defroster Grille

Courtesy of GENERAL MOTORS CORP.

Rotate to secure the DRL sensor to the defroster grille, if equipped.
Position the tabs along the front edge of the defroster grille down into the slots in the upper trim pad.
Lower the rear edge of the grille into position, then CAREFULLY press the rear tabs into place.