LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1271 (Disc Brake System) >> Repair Instructions >> Disc Brake Hardware Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Caliper Mounting Bolt, Bracket, Boot & Slid Pins
    GM695066Courtesy of GENERAL MOTORS CORP.
  1. Install the caliper pin boots (4) to the disc brake caliper mounting bracket.
  2. Lubricate the caliper pins (5) with high temperature silicone lubricant.
  3. Install the caliper pins to the disc brake caliper mounting bracket (3).
    4. Fig 2: View Of Brake Pads, Brake Pad Retainers, & Caliper Bracket
    GM727742Courtesy of GENERAL MOTORS CORP.
  4. Install the brake pad retainers (1) to the caliper bracket.
  5. Install the brake pads (2) to the caliper bracket.
  6. Install the disc brake caliper to the mounting bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the disc brake caliper bolts.

    Tighten:  Tighten the disc brake caliper bolts to 31 N.m (23 lb ft).

    Apply and release the brake pedal 3/4 stroke as many times as necessary in order to obtain a firm brake pedal.

scientia non olet · About LEMON Manuals