LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1419 (Body Rear End) >> Repair Instructions >> Liftgate Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Tail Gate Mounting View
    GM930633Courtesy of GENERAL MOTORS CORP.
  1. Position the lift gate hinges to the marked location points on the body, with an assistant.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    IMPORTANT: New hinge to body nuts must be used to ensure a proper seal.
  2. Install the lift-gate hinge attachment nuts inside the rear header.

    Tighten:  Tighten the lift-gate hinge nuts to 25 N.m (18 lb ft).

  3. Verify the alignment of the lift gate; adjust as necessary.
  4. Install the lift gate struts. Refer to Strut Replacement - Liftgate  .
  5. Install the lift gate wiring grommet, the connectors and the hose into the rear header.
    6. Fig 2: Lift-Gate Wiring Connectors
    GM930892Courtesy of GENERAL MOTORS CORP.
  6. Connect the 2 lift-gate wiring connectors.
  7. Connect the rear washer hose.
  8. Install the upper rear garnish molding. Refer to Garnish Molding Replacement - Rear Upper .
scientia non olet · About LEMON Manuals