LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 665 (Power Seat System) >> Repair Instructions >> Memory Seat Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide the module in until seated.
  2. Install the memory module retaining screws (1). Tighten the screws to 3 N.m (26 lb in).
  3. Connect the harness connectors (2).
  4. Install the seat cushion. Refer to Seat Cushion Frame Replacement - Front .
  5. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  6. If a new memory seat module is installed, the seat needs to be synchronized:
    1. 6.1. Operate the seat in all directions:
      • Front tilt
      • Rear tilt
      • Horizontal
      • Recline
    2. 6.2. If the seat stops part way due to programmed soft stop, release the switch and operate again in the same direction till the seat touches the mechanical stop
    3. 6.3. Repeat the above for all seat moving axes.
scientia non olet · About LEMON Manuals