Side Protector Installation
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the adhesive remaining on the side protector and the body using a razor.WARNING:
- Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
- Remove any grease or dirt from the adhesion surface of the side protector and the body.
- Attach double-sided adhesive tape to the side protector as shown in the figure.
Clearance
- 30 mm {1.2 in}
- 2.0 mm {0.08 in}
- 12 mm {0.47 in}
- 3.0 mm {0.12 in}
- 3.0 mm {0.12 in}
- 1.0-3.0 mm {0.04-0.11 in}
- 5.0 mm {0.2 in}
- 1.0 mm {0.04 in}
- Peel off the backing paper from the double-sided adhesive tape and attach the side protector onto the body as shown in the figure.
Clearance
- 1.4-4.4 mm {0.056-0.17 in}
- 3.0-6.0 mm {0.12-0.23 in}