LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2002 >> Aztek FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Pedal Assembly
    GM50412Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal to the bulkhead.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Reinstall the accelerator pedal bolt and stud.

    Tighten:  Tighten the bolts and studs to 3.0 N.m (27 lb in).

  3. Connect the accelerator cable to the accelerator pedal.
  4. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect the carpet fit under the accelerator pedal.
  5. Reinstall the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges, and Console.
scientia non olet · About LEMON Manuals