Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Pump Motor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
Install the EBCM to the BPMV.

NOTE: Refer to Fastener Notice .

Install the EBCM-to-BPMV attaching screws. Tighten the bolts in a cross pattern.
Tighten: Tighten the bolts to 3 N.m (27 lb in).
Connect the pump motor electrical connector.

Fig 2: Disconnecting/Connecting Electrical Connector From Electronic Brake Control Module (EBCM)

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the EBCM.

Fig 3: View Of Transmission Control Module

Courtesy of GENERAL MOTORS CORP.

Reposition the TCM, if equipped, to the mounting bracket.
Turn the ignition switch to the ON position. DO NOT start engine.
Perform the Diagnostic System Check - Vehicle .
Refer to Control Module References for programming and setup information.