Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the starter.




3. Disconnect the crankshaft position (CKP) sensor electrical connector.




4. Remove the CKP sensor retaining bolt.
5. Remove the CKP sensor.

INSTALLATION PROCEDURE




1. Install the CKP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor retaining bolt.

Tighten
Tighten the CKP sensor to 25 N.m (18 lb ft).




3. Connect the CKP sensor electrical connector.




4. Install the starter.
6. Perform the CKP System Variation Learn Procedure. Programming and Relearning