Ignition Control Module: Installation
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install ignition coil(s) onto ignition control module. Tighten ignition coil retaining bolts to specification. See TORQUE SPECIFICATIONS . Install ignition control module/coil assembly onto engine. See Figure.
- Tighten ignition control module/coil assembly mounting bolts to specification. Reconnect spark plug wires and ignition control module harness connectors. Lower vehicle. Connect negative battery cable and tighten negative battery cable-to-battery bolt to specification.
To install, reverse removal procedure. Tighten ignition control module retaining screws to specification. See TORQUE SPECIFICATIONS .