Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear run channel to the door.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the bolts that retain the rear run channel to the door.
Tighten

Tighten the bolts to 10 N.m (88 Ib. in).
Slide the window rearward into the rear run channel.
Install the front run channel to the door.
Install the bolts that retain the front run channel to the door.
Tighten

Tighten the bolts to 10 N.m (88 Ib. in).
Install the water deflector. Refer to WATER DEFLECTOR REPLACEMENT - DOOR .
Install the door trim panel. Refer to the appropriate procedure
- TRIM PANEL REPLACEMENT - SIDE REAR DOOR (UTILITY) or TRIM PANEL REPLACEMENT - SIDE REAR DOOR (EXTENDED CAB P/U ONLY)
- TRIM PANEL REPLACEMENT - SIDE FRONT DOOR
Fig 1: Installing Rear Run Channel To Door
Courtesy of GENERAL MOTORS CORP.